is there a source for toyota floor pans? or do you guys not bother and shape the metal yourself? the floor is rusted through in sopts around the body mounts. any recommendations for where to get it done? thanks in advance.

i couldnt find any aftermarket so i just shaped some metal i got from calgary metals and mig welded them in works awsome and cost me a total of $20 including the paint to paint them up.

Sounds like ya'll have the same problem as me !! Gotta love yodas!!

Hey man i had a serious floor problem in my xj! It couldn't find anything easy for it at all
this was the driver side... after i cleaned it all up


after a good week of welding.. smashing and bending of a 3footx8foot piece of galvanized sheet metal (16gauge) the floor was in



Its not that hard just time consuming. First time i helped do it we think it turned out pretty good.

Might help

How thick is 16 gauge in inches?

I used 1/8 inch plate for the floors of my '82 toy. I found that the body mounts under the floor were shot as well. With the 1/8 plate I shaped it right over the mounts and part way up the slope of the firewall. Once it was all in place I put the cab back on and drilled me a new hole for the body mount. Works great, and is definately stonger than the body mount was before.